Re-attaching the Brake light spring
Adjust the brake pedal where you want it. Reconnect the small spring to the brake light switch. Replacing the large spring is a little harder if you do not remove your floorboard. There are two ways to re-attach the spring.
1. Loop a piece of wire around the part of the spring that slips over the mounting peg. Pull up and slip the spring over the peg then pull the wire out.
2. On your back, using a flat blade screwdriver, push it vertically with the spring on the screwdriver tip and force it over the little peg it fell off of. If you removed the floorboards just lever the spring onto the peg with a small screwdriver. Replace the bolt back in the crank, job done.
No comments:
Post a Comment